MENU
  1. HOME
  2. Download
  3. Firmware for CE8000-130AP download

Firmware for CE8000-130AP download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

GRAPHTEC SOFTWARE LICENSE AGREEMENT (GSLA)

Downloading Files

Ver.1.07 (Latest version)

Date of updated16 Apr, 2025
Supported ProductsCE8000-130AP
Supported OSWindows 11 / 10
Downloading filesSoftwareCE8000APUPDATE_V107E.zip (3,554KB)
  • The plotter driver is required to be installed for use.
  • Please update the firmware according to the instructions to start cutting plotter properly.

Revision History

Ver.1.07

  1. Fixed the problem where pressing the ESC key on the Tool movement window displayed when Call Gin digitize instructions (C command) would not return to the previous screen.
  2. Fixed the problem where the OK button was displayed on two lines in the error window when the valid area for COPY mode is not wide enough.
  3. Improved the cutting quality when feeding long media.

Ver.1.06

  1. Fixed the problem that dashed lines specified with the LT command (HP-GL) or L command (GP-GL) would sometimes be set as solid lines.

Ver.1.05

  1. Fixed the problem that the position error occurred when changing tools.
  2. Fixed the problem that the Media Set Assist did not work when Media Change mode is activated.

Ver.1.04

  1. Fixed the problem that the WLAN MODULE ERROR would occur if the cut data size is large when using WLAN.
  2. Updated not to overwrite the error message “WLAN MODULE ERROR” with the other errors.

Ver.1.03

  1. Fixed the problem that a value in inches exceed the maximum value in expand settings.
  2. Fixed the problem that the display could not be operated when sending a command continuously via wireless LAN.
  3. Fixed the problem that cutting motion starts again when stopping the job and clearing the buffer under wireless LAN connection.
  4. Fixed the problem that [QUIT COPY] could not be selected when copying with [MEDIA CHANGE MODE] turned ON.
  5. Revised the Spanish text on the IP address setting menu.