MENU
Our website has been renewed!
  1. HOME
  2. Download
  3. Firmware for CE7000-130AP download

Firmware for CE7000-130AP download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

GRAPHTEC SOFTWARE LICENSE AGREEMENT (GSLA)

Downloading Files

Ver.1.30 (Latest version)

Date of updated13 Dec, 2023
Supported ProductsCE7000-130AP
Supported OSWindows 11 / 10
Downloading filesSoftwareCE7000AP_FU(v130).zip (3,358KB)
  • The plotter driver is required to be installed for use.
  • Please update the firmware according to the instructions to start cutting plotter properly.

Revision History

Ver.1.30

  1. Fixed the problem that crosscut starts when canceling while drawing USB flash memory data.

Ver.1.29

  1. Enabled to set the cutting conditions via USB flash memory using an offline setting file saved at [Remote Panel Utility].
    *Do not use flat type setting files.
    *Only available with the offline setting files saved at [Remote Panel Utility] with grid type other than CE7000-130AP    .

Ver.1.28

  1. Some updates have been made to improve serviceability.

Ver.1.27

  1. Fixed the problem that a “confirming push roller point” error would occur even though the push roller was set on the grit roller.

Ver.1.25

  1. Enhanced error detection of tool position errors.

Ver.1.24

  1. Fixed the problem that when reloading the media which was loaded once and selecting “CONTINUE” from the Select menu, the origin point when the media was first set was not correctly taken over.

Ver.1.23

  1. Fixed the problem that when sending cutting data with tool change while Auto Paneling was turned on, extra lines could be cut on the second sheet or incorrect condition numbers could be displayed.

Ver.1.22

  1. Fixed the problem that when a short length of media was crosscut, the media did not fall down to the basket.
  2. Fixed the problem tath the Initial Pre-feed length was not enough length. When the roll media was fed, it got tension.

Ver.1.20

  1. Fixed the problem that the blade consumption alarm of beep was not working for the group 8.
  2. Fixed the problem that when the USB memory of data was cutting, the cross cutting was not performed with the specified timeout setting.

Ver.1.10

  1. Fixed the problem of the cross cut disability issue on shorter data than separator length on segment cutting mode by time out.

Ver.1.04

  1. Fixed the problem that when the separator H was specified in the segment cutting mode, the cross cutter did not work correctly.
  2. The maximum alarm distance for Blade wear alarm setup was changed from the 5 km to the 100 km.

Ver.1.03

  1. Fixed the problem that the head move without tool position when the tool height did not reset after cutting was finished.