Support > Software & Drivers

Cutting Master for the Macintosh

 

OPS640

OPS640-MAC-VUP-E Cutting Master Ver. 3.60 OSX Update
Cutting Master is an output plug-in that enables the use of a Graphtec cutting plotter from within Adobe Illustrator CS on a Macintosh computer.

This version upgrade kit can only be installed if you already have an earlier version of Cutting Master for Macintosh, or if you have one of the following CD-ROMS supplied as a standard accessory when you purchased your Graphtec Cutting Plotter.

<FC5100 series>
PN: 53801-079T
PN: FC5100-CDM01M
PN: FC5100-CDM02M
PN: FC5100-CDM03M
PN: FC5100-CDM04M
PN: FC5100-CDM06M
PN: FC5100-CDM07M
PN: FC5100-CDM08M
PN: FC5100-CDM09M
PN: FC5100-CDM10M
<LC5200 series>
PN: LC5200-CDM02M
PN: LC5200-CDM03M
<CE3000 series>
PN: CE3000-CDM01E
PN: CE3000-CDM02M
PN: CE3000-CDM03M
PN: CE3000-CDM04M
PN: CE3000-CDM05M
<FC3600 series>
PN: FC3600-CDM01M
PN: FC3600-CDM02M
<FC612 series>
PN: FC612-CDM01M

Please be sure to read the instructions carefully before installing the driver.