Support > Hardware Help & Info

KW3320, 4320, 4620, 4623

Note: these pages are excerpted from the User's Manual, part number KW4320-UM-151.

DIP Switch Settings and Functions

4.0 Command Modes

Your digitizer comes equipped with functions that support Graphtec commands and other command sets. Thse command functions can be selected by setting the menu area. The five available command modes are above -- click on these links to jump to sections 4.2,. 4.3, 4.4, and 4.5.

The Command Modes

Click function key A of the menu area to select the command mode and access that mode's functions. For instructions on setting the menu area, see section 3.7, "Setting the Menu Area's Functions."

Function	Settings
Command mode	Graphtec commands	MM commands
	DT commands	Serial mouse mode
	Wintab Driver mode (beeper enabled)	Wintab Driver mode (Beeper disabled)

Your digitizer initially comes with the command mode set to Graphtec commands. For more information, see section 4.6 "Factory Default Settings."

Check:

Settings cannot be separately registered for each command mode. When the END key is pressed after changing any settings at the menu area, the previously registered settings will be updated.

4.1 Settings in the Graphtec Command Mode

Functions	Settings
Command mode	Graphtec commands
Baud rate	19200 bps	9600 bps
	4800 bps	2400 bps
	1200 bps	. . . . . . .
DATA length & No. of stop bits	8 bits, 2 bits	8 bits, 1 bit
	7 bits, 2 bits	7 bits, 1 bit
	. . . . . . .	. . . . . . .
Parity mode & Terminator	NONE, CR/LF	NONE, LF
	ODD, CR/LF	ODD, LF
	EVEN, CR/LF	EVEN, LF
Output format	ASCII	BINARY-1
	BINARY-2	. . . . . . .
	. . . . . . .	. . . . . . .
Step resolution	0.1 mm	0.025 mm
	0.005 in.	0.001 in.
	. . . . . . .	. . . . . . .
Data transmission mode	Remote	Point
	Stream	Switch Stream
	. . . . . . .	. . . . . . .
Data transfer rate (points/s)	MAX	100
	30	10
	. . . . . . .	. . . . . . .
Beeper & E-SW (Function extension switch) status	Beeper Enabled, E-SW Valid	Beeper Disabled, E-SW Valid
	Beeper Enabled, E-SW Invalid	Beeper Disabled, E-SW Invalid
	. . . . . . .	. . . . . . .

Note:

In the "Setting" column, an underlined setting indicates the default setting.

Any setting indicated as ". . . . . . ." specifies the default setting, so that value may be specified instead of the underlined setting.