Support > Hardware

KW3300, 4300, 4600

DT Command Set

Note: these pages are excerpted from the User's Manual, part number KW4300-UM-151.

4.0 DIP Switch Settings and Functions 7.1 DT Commands 7.2 HDG Commands
7.3 Bit Pad II Commands 7.4 MM Series Commands 7.5 Serial Mouse Mode

7.1 DIP Switch Functions

7.1.1 The DIP Switch Functions

The bits of this switch select the default settings of the resolution, output format, and data transmission mode.

Function		DIP Switch 1
		1	2	3	4	5	6	7	8
Output format	BCD (F + F2)	ON	ON	ON
	BCD (F)			OFF
	BCD (F2)		OFF	ON
	ASCII BINARY			OFF
	BINARY	OFF	ON	ON
Resolution	0.005 inch				ON
	0.1 mm				OFF
Data transmission mode	Point					OFF	OFF	OFF
	Stream							ON
	Switch stream						ON	OFF
	Idle							ON
	Increment					ON		OFF
Fixed to OFF									OFF

(b)

Settings of DIP Switch 2
The bits of this switch select the default settings of the RS-232C interface conditions and terminator character

Function		DIP Switch 2
		1	2	3	4	5	6	7	8
Logical Terminator	Append	ON
	Omit	OFF
Data length	7 bits		ON
	8 bits		OFF
Parity bit	NONE			OFF	---
	ODD			ON	OFF
	EVEN				ON
Stop bit	1 bit					ON
	2 bits					OFF
Baud rate	19200 bits/s						ON	ON	ON
	9600 "								OFF
	4800  "							OFF	ON
	2400  "								OFF
	1200  "						OFF	ON	ON
	600  "								OFF
	300  "							OFF	ON
	150  "								OFF

(c)

Settings of DIP Switch 3
The bits of this switch select the default settings of the command mode (DT emulation) coordinate pointer, beeper mode, etc.

		DIP Switch 3
		1	2	3	4	5	6	7	8
Command mode		OFF	OFF	ON
Stylus pen					OFF
4-button cursor					ON
Beeper	Enabled					ON
	Disabled					OFF
Fixed to OFF							OFF	OFF	OFF