Support > Hardware

KW3300, 4300, 4600

HDG Command Set

Note: these pages are excerpted from the User's Manual, part number KW4300-UM-151.

4.0 DIP Switch Settings and Functions 7.1 DT Commands 7.2 HDG Commands
7.3 Bit Pad II Commands 7.4 MM Series Commands 7.5 Serial Mouse Mode

7.2 HDG Command Set

7.2.1 Settings of DIP Switch 1

The bits of this switch select the sefault settings of the resolution, data transmission mode,
and data transfer mode.

Function		DIP SWITCH 1
		1	2	3	4	5	6	7	8
Resolution	0.025 mm	OFF	OFF	OFF
	0.05 mm			ON
	0.1 mm		ON	OFF
	0.254 mm			ON
	1000 lines/inch	ON	OFF	OFF
	400 lines/inch			ON
	200 lines/inch		ON	OFF
	100 lines/inch			ON
Remote mode					OFF	OFF
Switch stream mode					OFF	ON
Stream mode					ON	OFF
Point mode					ON	ON
Data transfer rate	2 data/s						OFF	OFF	OFF
	4  "								ON
	10    "							ON	OFF
	20    "								ON
	45    "						ON	OFF	OFF
	MAX								ON
	MAX							ON	OFF
	MAX								ON

(b)

Settings of DIP Switch 2
The bits of this switch select the default settings of the RS-232C interface conditions and terminator character.

Function		DIP SWITCH 2
		1	2	3	4	5	6	7	8
Terminator	CRLF	ON
	CR	OFF
Data length	7 bits		ON
	8 bits		OFF
Parity bit	NONE			OFF	--
	ODD			ON	OFF
	EVEN				ON
Stop bit	1 bit					ON
	2 bits					OFF
Baud rate	19200 bits/s						ON	ON	ON
	9600  "								OFF
	4800  "							OFF	ON
	2400  "								OFF
	1200  "						OFF	ON	ON
	600  "								OFF
	300  "							OFF	ON
	150  "								OFF

(c)

Settings of DIP Switch 3
The bits of this switch select the default settings of the command mode (HDG emulation), coordinate pointer, beeper mode, and enabled/disabled status of reading zero suppression.

This switch is used to set command compatibility to digitizers of other manufacturers.

Function		DIP Switch 3
		1	2	3	4	5	6	7	8
Command mode		OFF	ON	OFF
Stylus pen					OFF
4-button cursor					ON
Beeper	Enabled					ON
	Disabled					OFF
Reading zero suppression	Enabled						ON
	Disabled						OFF
Fixed to OFF								OFF	OFF