Support > Hardware

KW3300, 4300, 4600

Bit Pad II Command Set

4.0 DIP Switch Settings and Functions 7.1 DT Commands 7.2 HDG Commands
7.3 Bit Pad II Commands 7.4 MM Series Commands 7.5 Serial Mouse Mode

7.3 Bit Pad II Command Set

7.3.1 DIP Switch Functions

(a)

Settings of DIP Switch 1
The bits of this DIP switch select the default settings of the resolution, output format, coordinate system, data transmission mode, etc.

Function		DIP Switch 1
		1	2	3	4	5	6	7	8
Output format	ASCII	ON
	Binary	OFF
Resolution	0.005 inch		ON
	0.1 mm		OFF
Coordinate system	Relative			ON
	Absolute			OFF
PROX flag output	Enabled				ON
	Disabled				OFF
Remote mode						OFF	OFF	OFF	OFF
Point mode						ON	ON	OFF	OFF
Switch stream mode (Points/s)	150  data/s					OFF	ON	ON	ON
	65 "								OFF
	40 "							OFF	ON
	20 "								OFF
Stream mode (Points/s)	150   "					ON	OFF	ON	ON
	65 "								OFF
	40 "							OFF	ON
	20 "								OFF

(b)

Settings of DIP Switch 2
The bits of this switch select the default settings of the RS-232C interface conditions and terminator character

Function		DIP Switch 2
		1	2	3	4	5	6	7	8
Terminator	CR/LF	ON
	LF	OFF
Data length	7 bits		ON
	8 bits		OFF
Parity bit	NONE			OFF	--
	ODD			ON	OFF
	EVEN				ON
Stop bit	1 bit					ON
	2 bits					OFF
Baud rate	19200 bits/s						ON	ON	ON
	9600 "								OFF
	4800 "							OFF	ON
	2400 "								OFF
	1200 "						OFF	ON	ON
	600 "								OFF
	300 "							OFF	ON
	150 "								OFF

(c)

Settings of DIP Switch 3
The bits of this switch select the default settings of the command mode (Bit Pad II emulation), beeper mode, coordinate pointer, etc.

Function		DIP switch 3
		1	2	3	4	5	6	7	8
Command mode	BIT PAD TWO	ON	OFF	OFF
Stylus pen					OFF
4-button cursor					ON
Beeper	Enabled					ON
	Disabled					OFF
Increment setting	Disabled						OFF	OFF
	Step 1							ON
	Step 5						ON	OFF
	Step 10							ON
Fixed to OFF									OFF