KD3200, 3300, 3800, 4300, 4600 : MM Series Commands

Support > Hardware

KD3200, 3300, 3800, 4300, 4600

DIP Switch Settings and Functions

5.0 DIP Switch Settings and Functions 11.1 DT4100 Commands
11.2 HDG Command 11.3 Bit Pad Two Commands 11.4 MM Series Commands

11.4 MM Series Commands

Note:
the MM commands differ from the Summagraphics MM series with respect to the following points:

There is no X, Y Scale mode
There is no Self Test command

11.4.1 DIP Switch Setting Method

(a): DIP Switch SW1
DIP Switch SW1 is used to set the output format and coordinate reading mode

Function		SW1
Function		1	2	3	4	5	6	7	8
Output format	ASCII	ON
Output format	Binary	OFF
Terminator	CR LF		ON
Terminator	CR		OFF
Fixed				OFF
Beeper	Enabled				ON
Beeper	Disabled				OFF
Remote mode						OFF	OFF
Point mode						ON	ON
Switch stream mode						OFF	ON
Stream mode						ON	OFF
Data transfer rate	max/32							ON	ON
	max/8							ON	OFF
	max/2							OFF	ON
	max							OFF	OFF

(b): DIP Switch SW2
DIP Switch SW2 is used to set the resolution and data transfer conditions.

Function		SW2
Function		1	2	3	4	5	6	7	8
Resolution	500 lines/inch	ON
Resolution	0.1 mm	OFF
Data length	7 bits		ON
Data length	8 bits		OFF
Parity bit	NONE			OFF	*
	ODD			ON	OFF
	EVEN			ON	ON
Stop bit	1 bit					ON
Stop bit	2 bits					OFF
Baud rate	9600 bits/s						ON	ON	ON
	4800 "						ON	OFF	ON
	2400 "						ON	OFF	OFF
	1200 "						OFF	ON	ON
	600 "						OFF	ON	OFF
	300 "						OFF	OFF	ON
	150 "						OFF	OFF	OFF

*: Settable to either on or off
(c): DIP Switch SW3
DIP Switch SW3 is used to set the out-of-area data output and other-manufacturer compatible command functions.

Function		SW3
Function		1	2	3	4	5	6	7	8
Command mode	MM Series	OFF	OFF	OFF	ON	OFF	OFF	OFF	OFF