KD3200, 3300, 3800, 4300, 4600 : DT4100 Commands

Support > Hardware

KD3200, 3300, 3800, 4300, 4600

DIP Switch Settings and Functions

5.0 DIP Switch Settings and Functions 11.1 DT4100 Commands
11.2 HDG Command 11.3 Bit Pad Two Commands 11.4 MM Series Commands

11.1 DT4100 Commands

11.1.1 DIP Switch Setting Method

(a): DIP Switch SW1
DIP Switch SW1 is used to set the output format and coordinate reading mode

Function		SW1
Function		1	2	3	4	5	6	7	8
Output format	ASCII binary	OFF	OFF	OFF
	Binary	ON	ON	ON
	BCD (F)	ON	OFF	OFF
	BCD (F + F2)	ON	OFF	ON
	BCD (F2)	ON	ON	OFF
CURSOR/ pen status	1 (cursor)				ON
CURSOR/ pen status	0 (stylus)				OFF
Logical terminator	Appended					ON
Logical terminator	Not appended					OFF
Point mode							OFF	OFF	OFF
Stream mode							OFF	OFF	ON
Switch stream mode							ON	ON	ON
Idle mode							OFF	ON	ON
Increment mode							ON	OFF	OFF

(b): DIP Switch SW2
DIP Switch SW2 is used to set the resolution and data transfer conditions

Function		SW2
Function		1	2	3	4	5	6	7	8
Resolution	0.005"	ON
Resolution	0.1 mm	OFF
Data length	7 bits		ON
Data length	8 bits		OFF
Parity bit	NONE			OFF	*1
	ODD			ON	OFF
	EVEN			ON	ON
Stop bit	1 bit					ON
Stop bit	2 bits					OFF
Baud rate	9600 bits/s						ON	ON	ON
	4800 "						ON	OFF	ON
	2400 "						ON	OFF	OFF
	1200 "						OFF	ON	ON
	600 "						OFF	ON	OFF
	300 "						OFF	OFF	ON
	150 "						OFF	OFF	OFF

*1: Settable to either on or off
(c): DIP Switch SW3
DIP Switch SW3 is used to set the out-of-area data output and other-manufacturer compatible command functions.

Function		SW3
Function		1	2	3	4	5	6	7	8
Command mode	DT4100	OFF	OFF	OFF	OFF	OFF	OFF
O-AREA output	No output							OFF	OFF
	Output 1 time							OFF	ON
	Continuous output							ON	ON